aggregate 1.0.2

aggregate is a tool for aggregating CIDR networks. Input is read from stdin and output is written to stdout. It undestands IPv4 networks represented as network/prefix, network/netmask and start_address - end_addres. It is able to read input in any one of these formats and output in the same or a different format. It is also able to limit the maximum and minimum prefix length that will be output. This can be used to filter, for instance ignoring all networks with a prefix longer than 24 bits. That is all networks, smaller than a traditional Class C. The `configure shell script attempts to guess correct values for various system-dependent variables used during compilation. It uses those values to create a `Makefile in each directory of the package. It may also create one or more `.h files containing system-dependent definitions. Finally, it creates a shell script `config.status that you can run in the future to recreate the current configuration, a file `config.cache that saves the results of its tests to speed up reconfiguring, and a file `config.log containing compiler output (useful mainly for debugging `configure). If you need to do unusual things to compile the package, please try to figure out how `configure could check whether to do them, and mail diffs or instructions to the address given in the `README so they can be considered for the next release. If at some point `config.cache contains results you dont want to keep, you may remove or edit it. The file `configure.in is used to create `configure by a program called `autoconf. You only need `configure.in if you want to change it or regenerate `configure using a newer version of `autoconf. Whats New in This Release: - Out by one error in aggregation of ranges (again ). Verge Networks

Requirements:	No special requirements
Platforms:	Linux
Keyword:	Aggregate,  Cidr,  Configure,  Networking,  Networks,  Output,  System,  Tool
Users rating:	0/10