Jimsim Network Simulator 1.1

Jimsim Network Simulator project can emulate several routers connected via virutal networks. You can connect to the routers with your own favorite telnet program. Connecting to the Virtual Routers Use your favorite telnet program to connect to each of the virtual routers. For example: For router 1 type: C:>telnet localhost 10000 For router 2 type: C:>telnet localhost 10001 For router 3 type: C:>telnet localhost 10002 Network Layout Currently the network is configured like this: access-list [1-99] [permit/deny] [ ip wildcard-mask | host a.b.c.d | any ] ip acccess-list [standard] [name] ip access-group show access-list show ip interface show ip interface brief debug interface <> encapsulation [hdlc,ppp] (serial interfaces only) bandwidth clock rate (serial interfaces) interface loopback0 User commands: ? enable exit ping ip show cdp show cdp neigh show cdp neigh detail show interface show interface e0,eth0,etc show ip route show version Enable commands: clear counters clear counters interface config terminal copy running startup copy startup running debug all debug ip routing debug ip eigrp debug cdp disable exit reload show run show startup show ip eigrp neighbors show ip eigrp topology traceroute ip undebug all undebug ip routing undebug ip eigrp undebug cdp Config commands: cdp run enable password password end hostname banner motd delimiter banner exec delimiter banner login delimiter ip route network netmask dest interface e0,eth0,etc bandwidth value ip address addr netmask description cdp enable shutdown line con0, console0, console 0 login login local password passwd router eigrp number network a.b.c.d service password-encryption user username password password Limitations:.

Requirements:	No special requirements
Platforms:	Linux
Keyword:	Eigrp,  Interface,  Ip,  Jimsim,  Jimsim Network Simulator,  Network,  Network Simulator,  Networking,  Show,  Show Ip,  Simulator,  System
Users rating:	0/10