Teralogic 880 HDTV decoder Linux driver 0.2.3

Teralogic 880 HDTV decoder Linux driver.<br /><br />Remember that this driver has no video capture capability. The kernel module<br />uses three devices per TL880 card in /dev/tl880 to allow all users to mmap the<br />memory regions of the TL880, or use the ioctl interface to control the card.<br />The tools are then used to upload the firmware, set external sync, turn on color<br />bars, display a mouse cursor, and tweak the OSD. That's all that the driver can<br />do so far. There is also I2C bus support. For the latest known bugs, see the<br />web site and mailing list.<br /><br />To test the I2C bus(es), you will need the lm_sensors package. Load the<br />i2c-dev, i2c-algo-bit, and tl880.ko kernel modules, then run i2cdetect for each<br />bus displayed in the kernel message log (each card has a different number of<br />buses). If you have any output beside all XX's, note the address and bus<br />number, and run i2cdump [bus] [address]. For example, the NXT2000 on the MyHD<br />has address 0x14 on bus 1, so i2cdetect 1 shows a response from address 0xa, and<br />i2cdump 1 0xa shows the registers of the NXT2000.

Requirements:	No special requirements
Platforms:	*nix, Linux
Keyword:	Buses,  Calgobit,  Cdev,  Mailing,  Modules,  Package,  Sensors,  Tl880ko
Users rating:	0/10