Wolfram Mathworld Integrator

Three factors interfere in the determination of pellet mean size. These are the impeller speed, the binding solution and the pelletization time. We use experimental design (Doehlert design) to predict pellet mean size versus the three factors. We determine the quadratic model by multi-linear...

We use a batch column with four theoretical plates to separate a binary mixture of water and methanol at 1 bar. Temperature and concentration profiles versus time are obtained for a reflux ratio equal to 10. In addition, the total moles in the still and distillate are plotted versus time. This...

The code uses the SRK EOS written for a single component to plot isotherms, compute gas and liquid molar volumes and to plot vapor pressure versus temperature for ethane.Please visit these links for a paper by Z. Nasri and H. Binous where all equations are given as well as the same calculations...


Platforms: Matlab

We use the SRK equation of state to compute the correction factor due to gas-phase nonideality as a result of the high pressure applied in the ammonia synthesis. We also compute the extent of reaction. Plots of these two quantities versus pressure for temperature equal to 800K are presented. The...


Platforms: Matlab

Gas absorption is a very ubiquitous unit operation in any chemical plant. It has in common with liquid-liquid extraction that there are two carrier streams and one solute to be partioned between them. Here, we use the McCabe and Thiele graphical method to study the separation of acetone from air....


Platforms: Matlab

We would like to rise water temperature with a heater. Oulet temperature must be equal to the set point temperature (80dlT-C). Proportional (P), Proportional-Integral (PI) and Proportional-Integral-Derivative (PID) control are used and the respective results are compared. Inlet water temperature...


Platforms: Matlab

It is a new block simulink Phase Loop Control called the PLLVI1.The PLL control is utilized to synthetize frequency or phase control.You set a frequency input signal and VCOVI1,the volt control oscillator block simulink track the frequency input signal.The program has a problem of dimension of an...


Platforms: Matlab

The program shows how to plot figure 14.4 page 248 presented in T. L. Hill, An Introduction to Statistical Thermodynamics, Dover, New York, 1986. The Bragg-Williams approximation gives pressure-volume isotherms similar to those obtained using the van der Waals equation and it predicts first-order...


Platforms: Matlab

The program allows one to choose the best reactor setup among three alternatives: (1) a plug flow reactor with recycle, (2) a combination of a plug flow reactor and a stirred tank reactor in series and (3) two stirred tank reactors in series. This problem was solved graphically by O. Levenspiel...


Platforms: Matlab

The three-variable autocatalator is a prototype of complex dynamical behavior. Indeed, period doubling and chaos are found when the bifurcation parameter, nu, is varied between 0.10 and 0.20.The autocatalator's steps are the following:P->AP+C->A+CA->BA+2 B->3 BB->CC->DWhere P is a chemical...


Platforms: Matlab

In the program, we obtain equilibrium constants, compressibility factors, molar volumes and densities using the Soave-Redlich-Kwong equation of state. We find the same results as those given by Henley and Seader in Equilibrium-Stage Separation Operations in Chemical Engineering, Wiley, 1981...


Platforms: Matlab

The code computes the velocity profile for the vertical laminar flow of a Bingham fluid down a wall. As expected the profile is flat near the surface of the liquid film. In fact, we have a zero velocity gradient only when the shear stress is large enough (superior to tau0). This behaviour is...


Platforms: Matlab

The velocity and shear stress versus radial position are determined for laminar flow of a Carreau fluid in a pipe. The shooting method is used to verify the no-slip boundary condition at the piped-deOaos wall. Once the velocity at the center is determined, the governing Differential Algebraic...


Platforms: Matlab

Set of functions providing the attenuation and energy absorption coefficients of x-ray and gamma-ray photons in various materials, based on NIST report 5632, by J. Hubbell and S.M. Seltzer.X = PhotonAttenuation(Material, Energy, Options, Thickness)Function providing the attenuation and energy...


Platforms: Matlab

In the program, an example from the field of nonlinear chemical dynamics is presented. Governing equation and reaction scheme can be found in G. Nicolis, Dynamique Chimique, Thermodynamique, cindoTetique et mdoTecanique statistique, Dunod, Paris 2005. We use the arc length continuation method to...


Platforms: Matlab

The two programs computes residue curve maps for the methyl acetate and isopropyl acetate chemistries at atmospheric pressure. These calculations involve solving a complex system of differential algebraic equations (DAEs). This can be readily achieved using the built-in function of MatLab,...


Platforms: Matlab

It is the HEARTVI1FP1 block simulink of global functionnement of the heart with frequency and blood pressure.Training this block you will see that can happen a problem.One subsystem is the detection of frequency signal,and this block run well if utilized independantly,and this block runs well...


Platforms: Matlab

This is a Simulink Model Code of a guinea-pig ventricular action potential published byFaber GM, Silva J, Livshitz L, Rudy Y. Kinetic properties of the cardiac L-type Ca2+ channel and its role in myocyte electrophysiology: a theoretical investigation.Biophys J. 2007 92:1522-1543.The action...


Platforms: Matlab

The velocity and shear stress versus radial position are determined for laminar flow of a power law fluid in a pipe. The shooting method is used to verify the no-slip boundary condition at the piped-deOaos wall. Once the velocity at the center is determined, the governing equation is solved...


Platforms: Matlab

The files residu.m and residue2.m contain two functions called by the main program: calresd.m . The objective is to compute the residue curve map for the ternary system chloroform-acetone-methanol at 760 mmHg using the Wilson model to compute activity coefficients.Similar computations can be...


Platforms: Matlab