Mainm

This function opens a figure on screen. While in the figure, mouse button toggles the function on and off. While ON, the function samples and filters the mouse current location (in Realtime), and present both original and filtered points.This function was created as a routine University homework....


Platforms: Matlab

Read the main.m file. All paramters are editable by main.m. Also, the multirobot platform has not been implemented yet.


Platforms: Matlab

EOG Correction program is used to work out the amount of ocular potential recorded by the electroencephalograph [EEG] (as a proportion of the potentials recorded by the electrooculograph [EOG]), and to subtract this from the EEG. By doing this we are able to reduce the effect of ocular potentials...


Platforms: Matlab

Run the file main.m and everything works fine.The matrix A contains the data points and it can be changed in the file inputfile.m


Platforms: Matlab

This software will calculate all the constraint reactions of your shaft. Then you have the plot of blending moment of the forces that you have loaded and the plot of the torque screw.This is based on the statically determinate model of a simple supported shaft.The software is useful because you...


Platforms: Matlab

Quadtree decomposition of RGB image of size M-by-N-by-3. Three thresholds for red,green and blue components are used. For any R or G or B block if the maximum value of the block elements minus the minimum value of the block elements is greater than its respective threshold then the RGB block is...


Platforms: Matlab

non blocking tcpip event based sockets for Matlab.A small java class that implements a channel multiplexor in a separate thread and allows you to register socket connections and Matlab callback functions for socket channel events (OP_READ, OP_WRITE, OP_ACCEPT, OP_CONNECT). Leaves the command...


Platforms: Matlab

DQPSK over correlated Rayleigh ChannelDifferential QPSK communication is simulated over a Rayleigh channel, channel is correlated with Clark's or Jakes model,Run "main.m" to start.Doppler frequency can be changed in for different channels in "main.m"


Platforms: Matlab

A replacement for NSTask that supports blocks and output accumulation. See wiki or the test app's main.m.


Platforms: Mac